Detector
Power Supply (photodiode module에 전원을 공급하는 장치, Electronic Accessories)
Power Supplies, TE-Controllers, Pre-Amplifiers, Data Acquisition Systems, etc...
EOS manufactures support electronics for our detector products. This product line includes power supplies, preamplifiers, temperature controllers, lock-in amplifiers and a variety of custom data acquisition systems. Our goal is to deliver the right combination for each user's application.
One of the great advantages of these units is that the end user can directly plug them into any EOS receiver module without additional wiring. EOS electronics are designed for extremely low noise operation resulting in optimum detector system performance. All power supplies are CE Marked.
Below you will find our standard accessories:
PS-1 |
Low Noise Power Supply The PS-1 provides very low noise, +/- 15VDC. This unit operates with all EOS receiver modules, including all biasing requirements. In addition, the PS-1 works well as a general purpose, dual polarity laboratory power supply. Unless otherwise specified, the factory setting is 120VAC. The voltage is selected by rotating the small board beneath the fuse to read either 120 or 240. EOS can customize the number of channels of the PS-1 to power several receivers at once. Please review the one, two, and five channel specifications below. This product is CE marked. DATA SHEETS: PS-1 - PS-1/2C - PS-1/5C |
PS - 1B
 |
Ultra Low Noise - Battery Operated Power Supply The PS-1B is an ULTRA LOW NOISE, battery operated power supply designed primarily for powering all EOS' receiver modules and preamplifiers. The PS-1B will operate as a standard PS-1, or as a battery powered supply. In the PS-1 mode the output will be +/- 15VDC; in the battery powered mode, the output will be +/- 12V. This unit can be customized up to 2 channels. DATA SHEETS: PS-1B |
PS /TC-1
 |
Power Supply / TE Controller The PS/TC-1 combines the low noise +/- 15VDC power supply for the amplifiers with a closed-loop proportional controller and power supply for all the TE coolers offered with EOS detectors. The PS/TC-1 was designed specifically for the thermoelectric cooler control characteristics but can also be used a general purpose power supply. One of the great advantages of the PS/TC-1 is that the end user can directly plug it into any TE-cooled EOS receiver module without additional wiring. DATA SHEETS: PS/TC-1 Click Here for PS/TC-1 Operating Instructions |
LIA/PS-1
 |
Lock-In Amp / Power Supply The LIA / PS-1 is a combination lock-in amplifier and low noise power supply which powers all EOS receiver modules and interfacing to the receiver preamplifiers. In addition, the PS-1 works well as a general purpose, dual - polarity laboratory power supply. DATA SHEETS: LIA/PS-1 - LIA/PS-1/CC Click Here for LIA/PS-1 Operating Instructions Click Here for Application Set-up |
큐브셀 테크놀러지 E-Mail : info@cubecell.co.kr 핸드폰 : 010-4514-5977